Fa
En
Ar
ترجمه این پست به زبان های دیگر نیز روی سایت هست:
English 
Persian
Cutting glass without any tool
Special tools such as diamonds can be used to cut glass. But sometimes these tools are not found at home and we can try cutting glass without tools.
It is also sometimes difficult to cut arched glass, such as glass bottles using diamonds.
We use the following methods for this purpose:
Cutting glass with Soldering iron
Using Soldering iron for cutting glass is one of the most creative and low-risk ways to cut glass.
To do this, we will perform the following steps:
First, specify the place where the glass is cut with a marker.
2. If possible, line the cuts with a knife or diamond to make the work easier.
3. Hold the Soldering iron at one point to start the crack on the glass.
4. After cracking, move slowly in the same direction until cracking continues.
5. When you reach the angled points of the design, lower the Soldering System gently until the glass leaves the strainer.
6. Slowly remove the cut section.
7. At the end, remove the unevenness with the sandpaper to remove any roughness.
Cutting glass without any tool
Cut glass with candles
This method is almost similar to the previous method.
However, this method is not very suitable for high-angle designs.
1. Similar to cutting with Soldering iron, we first draw the pattern on the glass.
2. Using a diamond or a spatula, draw a line drawing.
3. Turn on the candle and place the line you draw them on the candle flame.
4. The cutting site is cracked and the glass is removed.
5. After it , remove the roughness.
Cutting glass with oil and water
In this way we do not need any special tools and only water, oil and a bowl are needed.
This method is usually used to cut glass bottles.
1. Put bottle in a bowl.
2. Fill the container to the point where we want it cut.
3. Fill the bottle exactly as much as the height of the water inside the bottle.
4. Gradually add the oil to the water until a thin layer of oil stay the surface.
5. Heat a metal blade until it is completely fried.
6. Slowly put the blade into the bowl and place under the oil.
7. If you have done the steps correctly you will hear the glass crackle.
Cutting glass without any tool
Note that no matter how professional you are with the glass, the work is not risky and requires concentration and precision.
MahjamGlass manufacturer of all kinds of mirror models.
Design from you, build from us.
You can decorate your home like a palace.
Connect with us on social networks:
And if you need email addresses and phone numbers, visit our contact page:
